Omron E5GC User Manual page 235

Set value
OFF
Manual
Stop
Alarm 1
Alarm 2
Alarm 3
Alarm 4
Alarm 1 to 4 OR status alm
Heater Alarm
Status display mes-
sage*
Note: The default is OFF.
* Selection is possible only with the E5DC and E5GC. (The E5DC must be manufactured in July 2014 or later
(version 2.2 or higher).)
Example: When ALM1 Is Selected for the SV Status Display Function
PV/SP
Additional Information
Priority of Flashing and Alternating Displays on No. 2 Display
The priority for flashing and alternating displays is as follows:
(1) Alternating display with SV status display
(2) Alternating display during program end output
The following procedure sets the PV Status Display Function parameter
to ALM1.
Operating Procedure
1
Press the M Key several times in the Advanced Function Set-
ting Level to display pvst (PV Status Display Function).
2
Press the U or D Key to select alm1 (alarm 1).
The default is off.
3
If the Alarm 1 status is ON in Operation Level, the PV and alm1
(Alarm 1) will be alternately displayed.
E5@C Digital Temperature Controllers User's Manual (H174)
Display
off
No SV status display
manu
MANU is alternately displayed during manual control.
stop
STOP is alternately displayed while operation is stopped.
alm1
ALM1 is alternately displayed during Alarm 1 status.
alm2
ALM2 is alternately displayed during Alarm 2 status.
alm3
ALM3 is alternately displayed during Alarm 3 status.
alm4
ALM4 is alternately displayed during Alarm 4 status.
ALM is alternately displayed when Alarm 1, 2, 3, or 4 is set to ON.
ha
HA is alternately displayed when an HB alarm or HS alarm is ON.
While one or more of the work bits (WR1 to WR8) is ON, the message
wr
for the highest bit number that is ON is alternately displayed with the
corresponding bit number.
Normal
When ALM1 Is ON
25 25
100 alm1
5 Advanced Operations
Function
Alternating
display
100
Advanced Function Setting
Level
pvst
off
pvst
alm1
Operation Level
25
100
5
PV Status
Display Function
alm1
5 - 59