Omron E5GC User Manual page 113

Indicators
Operation indicators
Keys
Key
Level Key
O
E5@C Digital Temperature Controllers User's Manual (H174)
Name
Auxiliary outputs 1 Each indicator lights when the function that is assigned to
corresponding auxiliary output (1 to 4) is ON.
to 4 (Only the
E5CC, E5EC,
E5EC-B, and E5AC
support auxiliary
output 3.) (Only the
E5EC, E5EC-B,
and E5AC support
auxiliary output 4.)
Control outputs 1 Each indicator lights when the function that is assigned to
corresponding control output (1 or 2) is ON. (For a linear current
and 2 (Control
output 1: E5CC, output, the indicator is not lit for values below 0%.)
E5CC-U, E5CC-B, For a Position-proportional Model, OUT1 lights when the open
E5EC, E5EC-B, or output is ON and OUT2 lights when the close output is ON.
E5AC only)
(Control output 2:
E5CC, E5EC, or
E5AC only)
Control output Each indicator lights when the function that is assigned to
(E5DC/E5GC only) corresponding control output is ON. (For a linear current output,
the indicator is not lit for values below 0%.)
Communications This indicator lights when wiring with communications is enabled.
writing
Manual This indicator is lit in Manual Mode.
Stop This indicator is lit while operation is stopped.
AT/ST in progress This indicator is lit during autotuning.
This indicator flashes during self-tuning.
Remote SP This indicator is lit while the SP Mode parameter is set to Remote
(E5CC, E5EC, SP Mode.
E5EC-B, or E5AC) This indicator flashes when there is an RSP input error in Remote
SP Mode.
Setting change This indicator is lit while setting change protection is ON.
protection
Name Overview
Selects the setting
level.
The next setting
level depends on
how long the key is
pressed.
3 Part Names and Basic Procedures
Description
Description
• In Operation Level
• Press once for less than 1 second to go to
Adjustment Level.
• Press for at least 3 seconds to go to Initial Setting
Level.
• In Adjustment Level
• Press once for less than 1 second to go to
Operation Level.
• Press for at least 3 seconds to go to Initial Setting
Level.
• In Initial Setting Level
• Press for at least 1 second to go to Operation
Level.
3
3 - 7