Omron E5GC User Manual page 332

6 Parameters
out1
out2
• These parameters set the function to assign to control outputs 1 and 2.
Function
tcmv
Setting
t-mv
t-pv
tspm
t-sp
*1 For the E5CC-U, E5DC, or E5GC with a linear current output, you can select these settings only
for the Control Output 1 Assignment parameter. (The E5CC-U must be manufactured in May
2014 or later (version 2.2 or higher) and the E5DC must be manufactured in July 2014 or later
(version 2.2 or higher).)
If c-o is assigned for standard control, a value equivalent to 0% is output.
*2
*3 Can be selected for relay and voltage outputs (for driving SSR) only.
*4 Can be selected when the Program Pattern parameter is set to OFF, but the function will be
disabled.
*5 WR1 to WR8 are not displayed when the logic operation function is not used.
*6 If the Standard or Heating/Cooling parameter is set to heating/cooling control, control
automatically switches to c-o.
6 - 80
Control Output 1 Assignment
Control Output 2 Assignment
Setting range
Simple transfer MV (cooling)
Simple transfer MV (heating)
Simple transfer PV
Simple transfer ramp SP
Simple transfer SP
none:
Disabled
o:
Control output (heating)
c-o:
Control output (cooling)
alm1:
*3
Alarm 1
alm2:
*3
Alarm 2
alm3:
*3
Alarm 3
alm4:
*3
Alarm 4
ha:
*3
Heater alarm
hb:
*3
HB alarm
hs:
*3
HS alarm
s.err:
*3
Input error
rs.er:
RSP input error
p.end:
Program end output
run:
*3
RUN output
alm:
Integrated Alarm
wr1:
*3*5
Work bit 1
wr2:
*3*5
Work bit 2
wr3:
*3*5
Work bit 3
wr4:
*3*5
Work bit 4
wr5:
*3*5
Work bit 5
wr6:
*3*5
Work bit 6
wr7:
*3*5
Work bit 7
wr8:
*3*5
Work bit 8
A Standard Model must be used.
A Standard Model with two control outputs must be
used.
Control Output 1 Assignment: o
*1
Control Output 2 Assignment: none
*1
*1
*1
*1
*2
*3
*3*4
*3
E5@C Digital Temperature Controllers User's Manual (H174)
Default
*6