Omron E5GC User Manual page 306

6 Parameters
tr-h
tr-l
• This parameter sets the upper and lower limit values of transfer outputs.
Function
output type
Setting
Set point
Set point
during SP
ramp
PV
MV
(heating)
MV
(cooling)
Valve
opening
*1 The remote SP will be output while the SP Mode parameter is set to the Remote SP Mode.
*2 This function can be set for a Position-proportional Model, but the setting will be disabled.
*3 This function can be set for standard control or for a Position-proportional Model, but the setting
will be disabled.
*4 This setting is displayed only for a Position-proportional Model.
Related Parameter
See
See
Transfer Output Type (Initial Setting Level): Page 6-53
6 - 54
Transfer Output Upper Limit
Transfer Output Lower Limit
Transfer
Setting range
SP lower limit to SP upper limit
*1
SP lower limit to SP upper limit
Temperature Input setting range
input lower limit to input
setting range upper
limit
Analog input Analog scaling
lower limit to analog
scaling upper limit
−5.0 to 105.0
Standard
*2
Heating/ 0.0 to 105.0
cooling
*3
−10.0 to 110.0
Position-
*4 proportional
control
000
There must be a transfer output.
The transfer output type must not be set to OFF.
000
Transfer output
lower limit
SP lower limit
Input setting
range lower limit
Scaling lower
limit
0.0
E5@C Digital Temperature Controllers User's Manual (H174)
Default
Unit
Transfer output
upper limit
SP upper limit EU
Input setting
range upper
limit
Scaling upper
limit
100.0 %