Omron E5GC User Manual page 28

1 Introduction
Event Inputs
• With any model that supports event inputs, you can use external contact or transistor inputs to
achieve any of the following functions: Switching set points (Multi-SP No. Switch, 8 points max.),
switching RUN/STOP, switching between automatic and manual operation, starting/resetting the
program, inverting direct/reverse operation, switching the SP mode100% AT execute/cancel, 40%
AT execute/cancel, setting change enable/disable, communications write enable/disable, and
canceling the alarm latch.
Communications Functions
With any E5@C model that supports communications, you can use CompoWay/F, Modbus-RTU,
programless, and component communications.
*1 Modbus is a registered trademark of Schneider Electric.
*2 The E5CC-U does not support communications.
Transfer Output
With any model that provides a transfer output, you can output the set point, process value,
manipulated variable, or other values as a 4 to 20-mA or 1 to 5-V transfer output. The E5CC-U,*
E5DC,* and E5GC do not have a transfer output, but if the control output is a linear current output,
the control output can be used as a simple transfer output.
* The E5CC-U must be manufactured in May 2014 or later (version 2.2 or higher) and the E5DC must be
manufactured in July 2014 or later (version 2.2 or higher).
Remote SP Input
With any model that provides a remote SP input, you can set the set point with an analog input.
* The E5CC-U, E5DC, E5GC, or E5CC-B does not have a remote SP input.
1 - 4 E5@C Digital Temperature Controllers User's Manual (H174)
*1