Omron E5GC User Manual page 100

2 Preparations
Connection Procedure
1
Connect the serial connector
on the USB-Serial
Conversion Cable to the
Setup Tool port on the top
panel of the Digital
Controller.
E5EC/E5EC-B/E5AC
Setup Tool Ports and Connecting Cables
The location of the Setup Tool port on the E5EC, E5EC-B, or E5AC and the required cable are shown below.
There are Setup Tool ports on both the top panel and front panel of the Digital Controller.
• Top panel on the Digital
Controller
* This Cable is required only to connect to the front-panel Setup Tool port.
Connection Procedure
• Top-panel Port
1
Connect the serial connector
to the Setup Tool port on the
top panel of the Digital
Controller.
2 - 64
Setup Tool ports
• Front panel on the
Digital Controller
Top-panel Setup
Tool port
Front-panel
Setup Tool port
Serial connector
Connecting cables
E58-CIFQ2
USB-Serial Conversion Cable
Serial connector
E5@C Digital Temperature Controllers User's Manual (H174)
E58-CIFQ2-E
Conversion Cable*