Table of Contents
Advertisement
24
Removing the Front Panel
The front cover may be removed to access the components. This is required when relocating the electrical or gas
inlet location. To remove the front cover
(a) Remove the center wingnuts.
(b) Loosen the two outer screws.
(c) Rotate the front panel down.
(d) Remove the front cover.
© Travis Industries
Installation
(for qualified installers only)
4/19/23 - 1453
1/4" Nutdriver/Wrench
PB 42 & 54 MV/GSB2/GSR2 Install
Advertisement
Table of Contents
