FireplaceXtrordinair ProBuilder 54 Installation Manual page 54

Table of Contents

Advertisement

54
MV Units Only - Starting the Pilot
Remove the glass frame before starting the pilot.
The pilot flame is required to ignite the main burners (it also
plays a safety role). It should be left on once lit. It will stay lit
unless the gas control valve is turned to "OFF" or if the burner
has not been lit in a 7 day period (see "Pilot Fuel
Conservation Timer" section on pg.55). However, the pilot will
go out if the gas is shut off, the propane tank runs out (or low)
or if the stove malfunctions. If the pilot turns off frequently,
call your dealer for information.
NOTE: Suggestions on how to limit the need to restart the pilot
during the heating season can be found on page 55
To start the pilot follow the directions below:
WARNING:
When lighting or re-lighting the pilot, the glass must be
removed (see page 57).
a
Remove the glass (see page 57).
b
Push the gas control knob in slightly and turn it to the "OFF"
position. The knob will not turn from "ON" to "OFF" unless
the knob is depressed slightly. Wait five minutes to let any
gas that may have accumulated inside the firebox escape.
If you smell leaking gas, follow the directions on the cover
"IF YOU SMELL GAS".
c
Turn the gas control knob to the "PILOT" position and press
the knob in, this will allow gas to flow to the pilot light.
Press the button on the pilot igniter repeatedly until you see
the pilot light.
WARNING:
If the pilot does not light after 15 seconds, release the knob
and call your dealer for service. Do not attempt to light
pilot until service has been performed.
d
Keep the gas control knob depressed for 30 seconds once it
is lit.
e
Release the gas control knob. If the pilot goes out, repeat
step C. If the pilot refuses to stay lit, call your dealer for
service. With the pilot lit, proceed to step "f".
f
Replace the glass.
g
Turn the gas control knob counter-clockwise to "ON". The
pilot is now lit and the heater can be turned on and off.
© Travis Industries
Installation
(for qualified installers only)
a
b
c
d
e
f
g
4/19/23 - 1453
5 minutes
PILOT
IGNITER
?
PB 42 & 54 MV/GSB2/GSR2 Install
30 seconds

Advertisement

Table of Contents
loading

This manual is also suitable for:

Probuilder 42

Table of Contents