FireplaceXtrordinair ProBuilder 54 Installation Manual page 69

4 Remove the switch from the dashboard by depressing the tabs on the top and the bottom of the switch
housing while pressing the back of the switch forward through the hole in the dashboard. Replace the switch
with the included switch blank (see pictures below).
5 On the inside left side of the front panel there is a bracket with two wing nuts secures the battery holder
(GSB2) or an empty bracket with two wing nuts.
GSB2 Version

Remove the wing nuts and set aside for
reinstallation. Disconnect the wires and Molex
connector from the main wire harness, remove
and discard the battery holder.
© Travis Industries
Installation
(for qualified installers only)

Remove the wing nuts and set aside for
reinstallation.
4/19/23 - 1453 PB 42 & 54 MV/GSB2/GSR2 Install
MV Version
69