FireplaceXtrordinair ProBuilder 54 Installation Manual page 47

Thin Facing (1/2" to 1-1/2")
When using thin facing you may remove the thick facing guide and tuck the facing underneath the screen
assembly. The screen assembly mounts may be adjusted to position the screen assembly directly against the
facing (see "Screen Assembly Mounts" below). To further illustrate this, note how the screen assembly mount is
moved forward in the 1" facing example below).
Screen Assembly Mounts
The screen assembly mounts (located on outer front edges of the fireplace) are adjustable to allow the screen
assembly to be positioned 1/2" (12mm) to 1-/12" (38mm) from the front of the fireplace. This allows facing to tuck
under the screen assembly. Each mount is held in place by (3) Philips head screws. Before mounting the screen
assembly, adjust the mounts so that the front edge is flush with the finish material surrounding the fireplace. To
adjust the mounts, loosen the screws, slide the mounts to the desired position, then tighten the screws.
© Travis Industries
Installation
(for qualified installers only)
Phillips
Screwdriver
Screen assembly mount
may be slid forward to
accommodate facing.
1/2" (13mm) Facing Example - Top View
Fireplace
Screen Assembly
Mount
1" (26mm) Facing Example - Top View
Fireplace
Screen Assembly
Mount
4/19/23 - 1453
Framing
Drywall
Max. 1/2" (13mm) Overlap
Framing
Drywall
Max. 1/2" (13mm) Overlap
Position edge of mount
flush with finish material
PB 42 & 54 MV/GSB2/GSR2 Install
47