Summary of Contents for FireplaceXtrordinair 564 25K
Page 1
564 25K & 35K Fireback Installation 96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205 Compatibility 564 35K 564 25K 564 CF 35K 564 CF 25K For 564 fireplaces built prior to those listed above (2019), floor firebacks (250-03768) may be needed to complete the installation.
Page 2
564 25K & 35K Fireback Installation 96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205 3. Remove the rear burner. Lift the rear burner straight up and remove it from the firebox. NOTE: there is a pin in each of the rear corners of the burner that hold the burner in the correct position.
Page 3
564 25K & 35K Fireback Installation 96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205 5. Lift the rear air deflector straight up and remove it from the firebox. 6. Remove the hearth front cover. Lift the cover and remove it from the firebox. Set the cover aside for reinstallation.
Page 4
564 25K & 35K Fireback Installation 96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205 7. All firebacks except black glass = Remove and discard the media tray covers. Black glass firebacks = Remove and keep the media tray covers for reinstallation.
Page 5
564 25K & 35K Fireback Installation 96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205 Place the rear fireback in position. Tilt the bottom of the fireback toward the rear wall of the firebox. Set the bottom of the fireback on the bent-out tabs on the rear of the media tray. The side firebacks installed in the next step will hold the rear fireback in place so, make sure to support the rear fireback until the side firebacks are installed.
Page 6
564 25K & 35K Fireback Installation 96100191, 96100198, 96100199, 96100200, 96100201, 96100202 ,96100205 11. Install the retaining clips on both sides to hold the side firebacks in place. 12. Restore the fireplace to the correct configuration. If using black glass firebacks reinstall the media tray covers. Slide the media tray covers to the outside to cover the gap between the media tray and the fireback panels.