Preventing Overvoltage During Deceleration (Stall Prevention During Deceleration Function) - Omron SYSDRIVE RV Series User Manual

Preventing Overvoltage During Deceleration (Stall Prevention During
Deceleration Function)
The Stall Prevention During Deceleration function makes the rate of deceleration more gentle to suppress
increases in DC bus voltage when the DC bus voltage exceeds the set value during motor deceleration.
This function automatically lengthens the deceleration time with respect to the bus voltage, even if the decel-
eration time has been set to a considerably small value.
If L3-04 is set to 1 or 2, when the main circuit DC voltage approaches the stall prevention level during decel-
eration, deceleration stops, and when deceleration falls below the level, is restarted. Using this operation,
deceleration time is automatically lengthened. If L3-04 is set to 1, deceleration time returns to the set value,
and if L3-04 is set to 2, deceleration is automatically adjusted to a faster deceleration time within the range of
the stall prevention level during deceleration.
Related Parameters
Param-
eter
Number
Stall pre-
vention
selection
during decel
L3-04
StallP Decel
Sel
* When using flux vector control, 0 to 2.
-30
6
Name
Description
Display
0: Disabled (Deceleration as
set. If deceleration time is
too short, a main circuit
overvoltage may result.)
1: Enabled (Deceleration is
stopped when the main
circuit voltage exceeds
the overvoltage level.
Deceleration restarts
when voltage is returned.)
2: Intelligent deceleration
mode (Deceleration rate
is automatically adjusted
so that in Inverter can
decelerate in the shortest
possible time. Set
deceleration time is
disregarded.)
3: Enabled (with Braking
Resistor Unit)
When a braking option
(Braking Resistor, Braking
Resistor Unit, Braking Unit)
is used, always set to 0 or 3.
Control Methods
Change
Setting Factory during
Range Setting Opera-
V/f
tion
0 to 3
1 No Q
*
Regis-
V/f Open Flux
ter
with Loop Vec-
PG Vector tor
Q Q Q 492H