Table of Contents
Advertisement
COOK I-flex
OPERATING INSTRUCTIONS
Shutting down
Cleaning and care
22
Unit model with castors
If the unit is standing on a sloped surface, it must be secured by extra means, such as wheel
chocks, in addition to applying the castor brakes to prevent it from rolling away accidentally.
Avoid subjecting the castors to excessive load to minimise the risk of damage to the castors:
•
Do not move the unit when the castor brakes are applied.
•
Avoid impacts.
•
Do not traverse bumps or steps.
•
Do not traverse uneven floors.
The unit should be pushed only, never pulled.
Always use 2 persons and two hands each when pushing the unit. Due to the weight of the unit,
if only one person pushes it there is a risk that they would not be able to apply the brakes quickly
enough.
Be careful not to pinch your hands between the unit and walls or other objects, such as cabi-
nets.
Due to the low floor clearance, transport the unit over inclined surfaces or ramps with a suitable
means of conveyance, such as a pallet truck.
Unit model with adjustable feet or built-in variant
Transport the unit over sloped surfaces or ramps using suitable means of transport, such as a lift
truck.
Disconnecting the mains plug
Insert and remove mains plug only while unit is switched off since, otherwise, the unit electrical
system can be damaged.
External devices connected to the optional unit socket outlets must also be switched off before
you connect or disconnect the mains plug.
Unit preparation
Switch off unit completely, including all cooking zones, and pull out the mains plug before
cleaning. Water penetrating into the unit can cause a short-circuit. This can result in malfunc-
tions. There is also risk of electric shock. Remove any connected external units. Always remove
objects from the storage surfaces and from the optional drawers.
Take off the odour filter box lid before cleaning the odour filter box. Pull mains plug of fan out of
unit socket outlet of odour filter box. Remove fan, including support plate, from the odour filter
box completely. Pull out the optional ION TEC and remove the charcoal filter pad. Take of the ex-
traction bridge lid. Remove the filter cassettes.
Advertisement
Table of Contents
