Cleaning And Disassembly Of The Engine Parts; Composition Of Transfer Belt Unit; Cleaning Of The Fusing Entrance Guide Plate - Minolta magicolor 7300 Service Manual

FrameMaker Ver.6E (PC) magicolor 7300 ASSEMBLY/DISASSEMBLY
02.08.08
2-5.

Cleaning and Disassembly of the Engine Parts

(1)

Composition of Transfer Belt Unit

4134D112AA
NOTE
• If the dry cloth is not effective in removing dirt, dampen it with toner or waste toner.
• Do not use a cloth wet with water.
• If any solvent is to be used, select one from among the following:
IPA, ethyl alcohol, PPC Cleaner, and Solmix AP-7.
• When the solvent has been used for cleaning, make 28 or more copies using A3 blank
sheets of paper to remove image noise.
(2)

Cleaning of the Fusing Entrance Guide Plate

4134D113AA
1. Remove the Transfer Belt Unit.
E-22 (Maintenance schedule)
2. Wipe the surface of the Transfer Belt with a dry
cloth.
1. Remove the Fuser Unit.
E-19 (Maintenance schedule)
2. Remove one screw, one stepped screw and the
Fusing Entrance Guide Plate Assy.
3. Using a dry cloth or cotton swab dampened with
alcohol, wipe clean the Fusing Entrance Guide
Plate.
NOTE
• Use care when cleaning the Fusing Entrance
Guide Plate as it is easy to damage.
• Be careful because the Fuser Unit can be hot.
• Do not set down the Fuser Unit with its terminal
down.
D-31