Table of Contents
Advertisement
FrameMaker Ver.6E (PC) magicolor 7300 Control PANEL/Panel Menu Operations
02.08.08
(5)
SYS DEFAULT
Item
Selects the language for the Message Window.
The initial values will differ according to the destination.
LANGUAGE
Models for Japan: Japanese, Models for the US and Europe:
ENGLISH
Sets the time for switching to Energy Saver mode when no print
jobs are received or no operation is performed on the Control
Panel. Starts Warm-up when a print job is transmitted during
Energy Saver mode.
SLEEP MODE
• When "SLEEP MODE" is selected, switches to either DEEP
SLEEP/LIGHT SLEEP/STANDBY MODE. In "STANDBY MODE"
the temperature of the heating roller is lower than when in
READY but higher than when in DEEP SLEEP/LIGHT SLEEP.
When set to OFF, Energy Saver mode is not enabled.
SLEEP TIMER
ENERGY SAVER
• Sets the time for changing to DEEP SLEEP/LIGHT SLEEP/
STAND BY MODE. The default is 30 minutes.
DEEP SLEEP MENU
• Only displays in "DEEP SLEEP" and defines the time period for
switching to "DEEP SLEEP". Once the time set for "SLEEP
TIMER" is exceeded and the current time is included in the time
period that has been defined, the printer immediately goes into
DEEP SLEEP. However, if the current time in not included in the
time period that has been defined, it goes into LIGHT SLEEP
and when the current time reaches the defined time, it goes into
DEEP SLEEP.
ERROR BEEP
• Sets whether to sound off the Buzzer when an error occurs.
BUZZER CONTROL
KEY CLICK
• Sets whether to produce a sound when a key is pressed on the
control panel.
JOB TIME OUT
• Sets the WAIT TIME for time period after a print job is requested
until a response is executed.
WAIT TIMEOUT
• Determines whether to initiate a TIMEOUT when there is no data
POSTSCRIPT
communication for a predetermined time period and the amount
of time that elapses before going into TIMEOUT. (Does not
TIMEOUT for 0 SECONDS)
ERROR REPORT
• Determines whether to issue a PostScript errors.
• Sets an access password to access INTERF ACE menu and
CHANGE
SYS DEFAULT.
PASSWORD
• The "0000" default means that no password is set.
Description
S-17
Advertisement
Table of Contents
Troubleshooting
