Removing Units; Removing The Print Head Unit - Minolta magicolor 7300 Service Manual

FrameMaker Ver.6E (PC) magicolor 7300 ASSEMBLY/DISASSEMBLY
02.08.08
2-4.

Removing Units

(1)

Removing the Print Head Unit

• Do not replace the Print Head Unit when the Power Supply is turned on.
Laser beam radiation may cause blindness.
• Do not disassemble or adjust the Print Head Unit.
Laser beam radiation may cause blindness.
1. Remove the Controller Box.
D-8(Control Board Removal Procedures 1 through 9)
CNPH1
CNPH2
4134D042AA
4134D043AB
4134D044AB
NOTE
2. Unplug two connectors on the Control Board.
3. Remove two screws, and the Ozone Filter Duct.
4. Remove five screws, and the ground wire.
D-22