Replacing The Units; Replacing The Print Unit - Minolta magicolor 7300 Service Manual

FrameMaker Ver.6E (PC) magicolor 7300 MAINTENANCE
02.08.08
3.

REPLACING THE UNITS

(1)

Replacing the Print Unit

<Removal Procedure>
NOTE
• When replacing the Print Unit, be sure to leave the toner cartridge installed in the print
unit to avoid spilling toner powder.
4134D035AA
4134E045AC
4134E005AC
4134E006AB
1. Turn off the Power Switch.
NOTE
• Always make sure to turn the printer off before
turning the power switch off.
2. Open the Front Door.
3. Check that the window on the Transfer Belt Unit.
If the indicator is red, a paper misfedd occurred
within the printer or the printer has been turned
off while operating. Remove the misfed paper,
close the Front Door, and the turn on the Power
Switch. After warming up is completed, turn off
the Power Switch.
NOTE
• Removing the Print Unit when the indicator is red
may damage the Image Transfer Belt.
4. Grasp the handle on the Print Unit Support Bar,
release the lock, and pull the bar forward.
5. Grasp the Print Unit Support Bar with both hands
to remove it.
E-10