Schwinn 270 Service Manual page 9

Condition/Problem
Unit rocks/does not sit
level
to pedal
Clicking sound when
pedaling
Seat Assembly shifts /
squeaks when in use
Workout results will not
sync with Bluetooth ® en-
abled device
Console Setup Mode – 170 / 270 series (MY17) Console
The Console Setup Mode lets you input the date and time, set the units of measurement to either English or Metric,
1. Hold down the PAUSE/END button and Right button together for 3 seconds while in the Power-Up Mode to go into
the Console Setup Mode.
Note:
2. The Console display shows the Date prompt with the current setting. To change, push the Increase/Decrease buttons
active value (month / day / year).
3. Push OK to set.
4. The Console display shows the Time prompt with the current setting. Push the Increase/Decrease buttons to adjust
(hour / minute / AM or PM).
5. Push OK to set.
6. The Console display shows the Units prompt with the current setting. To change, push OK to start the Units option.
Push the Increase/Decrease buttons to change between "MILES" (Imperial English units) and "KM" (metric units).
Note: If the units change when there is data in User Statistics, the statistics convert to the new units.
7. Push OK to set.
8. The Console display shows the Sound Settings prompt with the current setting. Push the Increase/Decrease buttons
to change between "ON" and "OFF".
9. Push OK to set.
Things to Check
Check leveler adjustment
Check surface under unit
Check pedal to crank
connection
connection
Check pedal to crank arm
connection
Hardware
Current console mode
Total time of workout
Fitness machine
Bluetooth enabled device Consult your device to be sure that the Bluetooth
®
Fitness App
Adjust levelers until machine is level.
even surfaces. Move machine to level area.
Pedal should be tightened securely to crank. Be sure connec-
tion is not cross threaded.
connected at 180 degrees from each other.
Remove pedals. Make sure there is no debris on threads, and
reinstall the pedals
Check hardware that attaches Seat assembly, and fully tighten
hardware.
Machine must be in Idle Mode to sync. Push the PAUSE/STOP
button until the Power-Up Mode screen is displayed.
A workout must be longer than 1 minute to be saved and
posted by the Console.
Unplug unit from electrical outlet for 5 minutes. Reconnect to
outlet.
feature has been enabled on it.
is compatible.
Contact appsupport@nautilus.com (if inside US/Canada)
or your local distributor (if outside US/Canada) for further
assistance.
9
Solution
wireless
®
-