Schwinn 270 Service Manual page 61

6. Put the Drive Belt (B) onto the Drive Pulley (A). Slowly turn the
Drive Pulley backward and carefully ease the Drive Belt onto the Drive
Pulley. Make sure the Drive Belt is aligned on the Flywheel pulley (G), Belt
Tensioner (H) and Drive Pulley. Be sure that the upper portion of the Drive
Belt is under the bearings on the Belt Tensioner (H).
turn the Drive Pulley.
7. Before fully attaching the Shrouds, verify that the RPM Sensor (I)
and Speed Sensor Magnets (J) on the Drive Pulley do not touch.
8. Make sure that the belt tension is correct. Refer to the "Belt Tension
Adjustment" section in this manual.
Note: This step may require two people.
9. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
B
I I
Recumbent bike
61
A
H
G
J J
I I
J J