Schwinn 270 Service Manual page 18

NOTICE: It is necessary to remove the shrouds for this procedure. Refer to the "Replace the Shrouds" procedure.
Note: Your machine may not match the image. For reference only.
1. Disconnect and reconnect the AC Adapter from the wall outlet
to turn the power off and on.
2. Push QuickStart and verify that the console shows that the
default resistance level is 4.
Disconnect all power from the machine.
3. Carefully remove the Left Shroud and Right Shroud. (Refer
to the "Replace the Shrouds" procedure.) Turn the Top Shroud to
keep it clear of the pulley assembly. Keep the Power Inlet cable
(P) in the Shroud connected to the wiring harness on the motor
(D).
Note: If it is necessary to remove the Top Shroud, reinstall
the Console and Mast.
4. Insert 2.5" x 10" cardboard between the Brake Magnet
(A) and the Flywheel (B), and tape the cardboard to the Brake
Magnet.
Note: Be sure the cardboard covers all of the Brake Magnet.
4. Turn the power on again.
Machine is on. Current is active. There is risk of electrical
shock.
5. Use the console to set the resistance to the highest level.
This moves the Brake Magnet Arm (A1) forward. After the Brake
Magnet Arm stops at the highest resistance level, turn power off.
Disconnect all power from the machine.
Left side
A
A1
D
Right side
18
B
A1
P
B
A
D