Schwinn 270 Service Manual page 36

!
Disconnect all power to the machine before you service it.
Note: Your machine may not match the image. For reference only.
1. Remove screws that attach Console to the Mast. Carefully lift the
Console off the Mast.
2. Disconnect the Data Cable and Heart Rate Cable from the
back of the Console. Set the Console and screws safely aside for
reassembly.
Note: Do not let the cables fall down inside the Mast or Frame.
3. Bend the edges of the Top Shroud to disengage the inside tabs
from the Main Assembly, and slide the Mast Gasket and Top Shroud
up the Mast.
4. Remove the hardware (indicated) from the Mast. Gently pull
the Mast out and disconnect the cables. Set the hardware, Mast
Gasket and Top Shroud safely aside for reassembly. Discard the old
Mast.
NOTICE: Do not cut or pinch the cables.
This step may require two people.
5. Installation is the reverse procedure.
NOTICE: Make sure the cable connectors do not fall into the
Console Mast. Align the clips on the cable con-
nectors and make sure the connectors lock. Do
not crimp the cables. Be sure the tabs on the Top
Shroud snap into the Main Assembly.
6. Connect the cables to the back of the Console and attach the
Console to the Mast.
NOTICE: Do not cut or pinch the cables.
7. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
36