Schwinn 270 Service Manual page 50

6. Installation is the reverse procedure. Tape the cardboard to
the new Brake Magnet. Be sure the cardboard will completely
cover the new Brake Magnet before installation.
NOTICE: Do not cut or pinch the cables.
7. Before fully attaching the Shrouds, remove the cardboard
from between the Brake Magnet (A) and the Flywheel (B). Power
up the machine to verify that the Magnet Arm can move freely, and
that the Brake Magnet and Flywheel do not touch at the maximum
resistance level.
Machine is on. Current is active. There is risk of electrical
shock.
If necessary, refer to the "Set the Brake Tension" procedure.
8. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
50