Schwinn 270 Service Manual page 29

Note: Your machine may not match the image. For reference only.
1. Loosen and remove the screw (A) from the old Transport
Wheel assembly (B), and set it safely aside for reassembly. Remove
the old Transport Wheel assembly from the front stabilizer (C), and
discard.
2. Install the replacement Transport Wheel assembly.
Note: Be sure the plastic alignment tab on the wheel assembly
goes into the slot (D) at the end of the stabilizer tube.
3. Final Inspection
Inspect your machine to ensure that all hardware is tight and
components are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
A
29
C
B
D D