Schwinn 270 Service Manual page 39

6. Tie the length of string to the end (A) of the Data Cable
at the base of the Mast. Hold the other end of the Data Cable
(B) and carefully pull it out of the Mast so that the string
the old Data Cable and discard the old cable.
NOTICE: Hold the HR Cable (C) so that you do not pull
it out of the Mast. Do not cut or pinch the HR
cable.
7.
Tie the end of the string at the base of the Mast to one
end of the replacement Data Cable. Hold the other end of
the string and carefully pull the new Data Cable through the
Mast.
NOTICE: Hold the HR Cable (C) so that you do not
pull it out of the Mast. Do not cut or pinch the
cables.
8. Untie the string from the Data Cable and connect the
cable to the Data Cable from the Main Frame.
. NOTICE: Do not cut or pinch the cables. This step may
require two people.
9. Put the Mast (with the Top Shroud) back in position in the
Main Frame and reinstall the Hardware.
Note: Do not let the cables fall down inside the Mast.
NOTICE: Be sure not to cut or pinch any cables. This
step may require two people.
10. Slide the Top Shroud back into position and and reinstall
NOTICE: Be sure the tabs in the Top Shroud snap into
the Main Assembly.
11. Connect the cables to the back of the Console and
attach the Console to the Mast with the screws from Step 2.
NOTICE: Do not cut or pinch the cables.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled and
inspected for correct performance in accordance with the
Owner's Manual.
B
39
C
A