Schwinn 270 Service Manual page 43

NOTICE: This document provides instructions for the replacement of the Seat Rail and Seat Slider Assembly on the Schwinn
Journey 2.5 Recumbent Bikes.
If you need assistance, please contact Customer Service (if purchased in US/Canada) or your local distributor (if purchased outside
This icon means a potentially hazardous situation which, if not avoided, could result in death or serious injury. Read and
understand all Warnings on this machine.
Nautilus, Inc., (800) NAUTILUS / (800) 628-8458, www.NautilusInc.com - Customer Service: North America (800) 605-3369, csnls@nautilus.com | outside U.S. www.nautilusinternational.com | © 2019 Nautilus, Inc. |
Schwinn is a trademark licensed to Nautilus, Inc., which is registered or otherwise protected by common law in the United States and other countries. |
Important Safety Instructions - Before servicing or using this equipment, obey the following warnings:
This icon means a potentially hazardous situation which, if not avoided, could result in death or serious injury. Read and understand all
Warnings on this machine.
Disconnect all power to the machine before you service it.
• Keep bystanders and children away from the product being serviced at all times.
• Some components of the equipment can be heavy or awkward. Enlist the service of a second person when you do
maintenance steps involving these components. Do not try to do heavy or awkward steps on your own.
• If replacement parts are necessary, use only genuine replacement parts and hardware supplied by Nautilus. Failure to use
genuine replacement parts can cause a risk to users, keep the machine from operating correctly and void the warranty.
• Be sure that all warning stickers and instructional placards applied to the product stay present and in good condition when
doing maintenance or replacing components. If at any time the Warning labels become loose, unreadable or dislodged,
replace the labels. If purchased in US/Canada, contact Customer Service for replacement labels. If purchased outside US/
Canada, contact your local distributor for them.
• Do not put the machine back in service until all shrouds, instructions, warning labels and correct functionality have been
SAVE THESE INSTRUCTIONS.
•
Tools Required (not included)
#2 Phillips screwdriver
13mm open end wrench
6mm hex wrench
4mm hex wrench
Replace the Seat Rail Assembly on the Schwinn
TM
and Journey 2.5 Bikes
43
™
270 Replacement Procedure
™
270 and
ORIGINAL DOCUMENT - ENGLISH VERSION ONLY
Skill Level: II
8024444.030123.B