Schwinn 270 Service Manual page 42

6. Tie the length of string to the end (A) of the HR Cable at the
base of the Mast. Hold the other end of the HR Cable (B) and
carefully pull it out of the Mast so that the string extends through
the length of the Mast. Untie the string from the old HR Cable and
discard the old cable.
NOTICE: Hold the Data Cable (C) so that you do not pull it out
of the Mast. Do not cut or pinch the Data Cable.
7. Tie the end of the string at the base of the Mast to one end
of the replacement HR Cable. Hold the other end of the string and
carefully pull the new HR Cable through the Mast.
NOTICE: Hold the Data Cable (C) so that you do not pull it out
of the Mast. Do not cut or pinch the cables.
8. Untie the string from the HR Cable and connect the cable to the
HR Cable from the Main Frame.
. NOTICE: Do not cut or pinch the cables. This step may require
two people.
9. Put the Mast (with the Top Shroud) back in position in the Main
Frame and reinstall the Hardware.
Note: Do not let the cables fall down inside the Mast.
NOTICE: Be sure not to cut or pinch any cables. This step may
require two people.
10. Slide the Top Shroud back into position and and reinstall the
Mast Gasket.
NOTICE: Be sure the tabs in the Top Shroud snap into the Main
Assembly.
11. Connect the cables to the back of the Console and attach the
Console to the Mast with the screws from Step 2.
NOTICE: Do not cut or pinch the cables.
12. Final Inspection
Inspect your machine to ensure that all hardware is tight and components
are properly assembled.
Do not use until the machine has been fully assembled
and inspected for correct performance in accordance
with the Owner's Manual.
B
42
A
C