Console Service Mode - Schwinn 270 Service Manual

10. The Console display shows the TOTAL RUN HOURS for the machine.
the value (NO/YES). If YES is selected, the Console setup, user records and workout records will be reset to defaults.
16 . The Console will display the Power-Up Mode screen.
Console Service Mode – 170 / 270 series (MY17) Console
SERVICE MODE is a sub-menu from the CONSOLE SETUP MODE. Most of the options contained within the Service
Mode are for Service Technicians and should not need to be used by a user.
To access the Engineering Mode:
1. From the Power Up (or Welcome) screen, push and hold down the PAUSE/STOP button and Right arrow button for
about 5 seconds to go into the Console Setup Mode. The Console display will show the Date prompt with the current
setting.
Note:
2. Push the OK button 4 times until the Console displays the TOTAL RUN HOURS screen.
seconds. The Console display shows the Firmware Version string. Push the Up/Down buttons to move through the
series of tests similar to the tests listed below, but optimized to be run on the production line. Use of this chained
test should not be necessary anywhere but on the production line.
b. The main processor SoftwareVersion prompt is displayed.
1. All LEDs On 1 second
1. All LEDs On 1 second
displays contact heart rate.
displays wireless heart rate.
The numbers displayed on LCD should be within normal range and match with the test subject or simulator.
reading string.
®
10