Schwinn 270 Service Manual page 45

6. Carefully disconnect the Heart Rate Cables.
7.
bracket arms at the front of the Seat Frame. Using a 6mm
Frame. Remove the Seat Frame Assembly. Set the hardware
and Seat Frame Assembly safely aside.
NOTICE: Do not cut or pinch any cables.This step may
require two people.
8.
Using a #2 Phillips screwdriver, loosen and remove the
screw that secures the front Seat Rail End Cap. Bend the
edges of the rear Seat Rail End Cap to disengage the inside
tabs from the Main Assembly, and remove. Set the hardware
and Caps safely aside for reassembly.
9.
Using a #2 Phillips screwdriver, remove the screws
(indicated) that secure the Left Rear Shroud. Remove the
the Left Shroud. Set the hardware and Left Shroud safely
aside for reassembly.
45