Table of Contents
Advertisement
WORKSHOP MANUAL
e-PARK 220
c) Blades' motor
The electric motor operating the blades is supplied by an external man-
ufacturer and it is built to precise technical specifications that set it apart
from other similar products produced by the same manufacturer. The
serial number on the label (3) allows the product and its characteristics
to be correctly identified and must be always mentioned when ordering
spare parts or requesting information from the Manufacturer.
2.1.2 Safety measures to be adopted
All the machines are manufactured in accordance with the strict European safety regulations in
force. To maintain these levels of safety in the longer term, the Service Centres should work to this
end by making appropriate checks every time there is the chance to do so.
In particular, every time there is work done on the machine the Service Centre should:
• check:
- the correct functioning of the safety devices;
- that the casings and protection covers have not been removed;
- that the labels with instructions or provisions have not been removed or have become illegible
(these form an integral part of the safety system).
• and also:
- restore to proper working order any safety devices which have been manipulated or removed;
- reassemble inefficient, damaged or missing casings and protection covers;
- replace all illegible labels, follow-
ing the illustration below;
- clean the inside of the cutting deck
with water and a non-metal bristle
brush;
- touch up the painted parts where
the paint is scratched or missing;
- not endorse any repair or modifi-
cation on the machine or the mo-
tor which results in a change in
performance or use that is incor-
rect or different from the purpose
for which it was designed and ap-
proved;
- warn the Customer that failure to
comply with the above points au-
tomatically voids the warranty and
the responsibility of the Manufac-
turer.
CHAPTER
2 - INFORMATION FOR SERVICE CENTRES
EDITION
PAGE
2018
9 /
84
3
Advertisement
Chapters
Table of Contents
