Menu "Service Mode" And Diagnostics; Accessing And Exiting The "Service Mode" Menu; Elements Description Of The Graphic Interface - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220

9.4.1 Accessing and exiting the "Service Mode" menu

In the "Service Mode" menu, you will find all the useful information on the status of the machine
and any malfunctions.
NOTE Access to the various functions of the menu always requires the presence of the operator,
seated at the driver's seat.
•To access the menu it is necessary:
– To release the emergency stop button (3).
– To operate the brake pedal and hold it down.
– To turn key (1) to position « » and hold it in this position for 2",
then release it so that it moves into position « » activating
the machine.
– To press the Cruise Control for 5 seconds.
– To release the brake pedal.
• To exit the menu it is necessary:
– To turn key (1) to position« » and switch off the machine, or:
– Press the brake pedal and hold down the Cruise Control for 5 seconds.

9.4.2 Elements description of the graphic interface

The upper part of the window (a) displays the messages concerning the state of the computer
connections that control the exchange of information between the various management software
The meaning of the mes-
sages is shown in the table
below.
NO CAN BUS
NO CAN BUS
AC-0 COM
ACE-0 COM
9 - ELECTRONIC MANAGEMENT - BATTERY

9.4 MENU "SERVICE MODE" AND DIAGNOSTICS

MESSAGE
BMS COM
NO CAN BUS
NO CAN BUS
CHAPTER
Physical connection interrupted between VMS and display
Physical connection interrupted between VMS and BMS
Connection interrupted between VMS and AC-0
AC-0 control unit fault
Connection interrupted between VMS and ACE-0
ACE-0 control unit fault
EDITION
2018
2
1
a
Meaning
PAGE
68 /
84
3