Replacing The Steering Shaft And Steering Bushes - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220

4.2.3 Replacing the steering shaft and steering bushes

NOTE The delay in wheel response to steering wheel operation indicates wearing of the control
pinion, while the mobility and play felt on the steering column can be attributed to wear on the
bushes.
1. Remove the footplate as instructed in the "Footplate removal" procedure
2. Remove the steering wheel display and steering wheel column as instructed in the "Removing
and replacing the steering column and steering wheel" procedure
3. Release the chain from the steering pinion as described in points 1, 2 and 5 of the "Replacing
the chain and steering cables" procedure
4. Unscrew the grab screw (1) and remove the
ring (2).
5. Remove the shaft from below (3).
If the bushes also have to be replaced (5) they
can be removed from their respective mountings
without the use of any special tools.
When assembling, perform the above steps
backwards.
WARNING!
is always necessary to adjust the cables
[ 4.2.2].
4
When reassembling the shaft (3) remember to reset the bush (4) at the
shaft end, which is essential for the correct positioning of the display
rod.
After resetting the chain, it
CHAPTER
4 - STEERING
[ 4.2.1].
2
1
5
3
4
EDITION
2018 30 /
[ 3.1.4].
[ 4.1.2].
3
PAGE
84
5