Lifting System; Replacing The Lifting Actuator - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220
– Release of the torque limiter (4) between the
gear wheels and the blade shaft. In the normal
situation, the arrows must be turned in the op-
posite direction to each other as shown in the
image. If the torque limiter is released, the ar-
rows do not point in the opposite direction.

7.2.1 Replacing the lifting actuator

1. Remove the cover of the cutting deck (1) fixed
by the two screws (2).
2. Remove the clamp (3) and disconnect the
connector(4).
3. Remove the spring rings (5), pull out the pins
(6) and remove the actuator (7).
When mounting, perform the above steps back-
wards
CHAPTER
7 - MOWING DECK

7.2 LIFTING SYSTEM

2 2
7
5 6
EDITION PAGE
2018 46 /
84
4
1
5
6
3
4