Replacement Of The Motor Brake - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220

5.1.3 Replacement of the motor brake

The electric motor of the transmission unit is equipped with a brake, which intervenes in the event
of a power failure to the motor and therefore has a parking brake function.
WARNING!
a parking brake is completely lost and therefore wedges must be placed in front of
the front wheels to prevent any accidental movement of the machine.
WARNING!
of 30% (16°) with the driver in position.
If this is not the case, the brake must be replaced.
1. Remove the left-hand rear wheel.
2. Disconnect the connector (1).
3. Pull out the spring pin (2) and remove the link-
age (3) of the brake release device with the
help of a 3 mm pin punch.
4. Remove the brake unit (4) by removing the
three screws (5).
When mounting, reverse the operations de-
scribed above, taking care to:
– align the new brake so that the cable output
with the plug connector (1) is at the top;
– tighten the three screws (5) with a torque
wrench of 4.5 Nm.
5 - TRANSMISSION UNIT - WHEELS
With the removal of the brake from the transmission unit the function of
The parking brake should prevent the machine from moving on a slope
[
CHAPTER
5.2.2].
1
5
5
EDITION
2018
3
2
5
PAGE
33 /
84
4