Removing And Replacing The Steering Column And Steering Wheel - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220

4.1.2 Removing and replacing the steering column and steering wheel

NOTE The operation will be made easier by positioning the machine with the two parts aligned
with each other and the steering wheel straight.
1. Remove the display rod following steps 1 to 4 of the "Removal and assembly of the display"
procedure
2. Unscrew the three grub screws(1) and pull
out the steering column (2) with the steering
wheel.
NOTE The steering wheel and steering col-
umn are supplied as a spare part like a pre-
assembled unit. In case of replacement, some
parts must be recovered and reassembled on
the new component, as shown below.
3. With the help of a screwdriver, release the two
internal tabs (3), remove the cover (4) of the
steering wheel (5) and refit it to the new steer-
ing wheel by snapping it in.
4. Reassemble the steering column (2) on the
steering shaft (6). Position the steering wheel
knob at the top, so that the two protrusions are
perpendicular to the axis of the machine, in or-
der to be aligned with the corresponding shaft
compartments.
5. Screw the three grab screws back in (1) and
tighten them well.
NOTE The position of the three grab screws
along the circumference of the steering col-
umn is such as not to allow orientation errors
during assembly, the correctness of which is
proved by the complete screwing of the grab
screws.
When assembly, carry out the above steps in reverse order, making sure to comply with steps 7 to
9 of the "Removal and assembly of the display" procedure
[ 4.1.1].
CHAPTER
4 - STEERING
2
1
4
3 1
3
6
[ 4.1.1].
EDITION PAGE
2018 26 /
84
1
5
2