WORKSHOP MANUAL
e-PARK 220
Summary
6.1
BLADES MOTOR ...................................................................................... 35
6.2
6.1.1 General description
The blades are powered by a three-phase 1.7 kW, 5 kW DC brushless electric motor.
The motor is equipped with a temperature sensor connected to the electronic management sys-
tem.
6.1.2 Removal of the motor unit from the machine
1. Make the carter moveable under the seat, following steps 1 - 3 - 4 - 5 of the "Removing the
carter under the seat" procedure, without disconnecting the control connectors
2. Removing the blades motor housing
3. Disconnect all the electric cables from the
ACE-0 control unit, following the procedure
"Replacing the ACE-0 control unit"
Disconnect the connector (1) and remove the
wiring from the cable clamp (2).
IMPORTANT These operations must be car-
ried out only when the motor is replaced, while
work on the clutch can be carried out with the
wiring connected.
6 - BLADES MOTOR - CLUTCH AND PTO
6 - BLADES MOTOR - CLUTCH AND PTO
6.1 BLADES MOTOR
CHAPTER
[
3.1.3].
[
9.5.3].
2
EDITION
2018
[
3.1.2].
1
PAGE
35 /
84