Steering Cables Adjustment - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220
10. Reassemble the two adjusters
(4) on the rear frame and carry
out a preliminary tensioning.
11. When refitting the bracket (2),
make sure that the screw (14)
that ensures the positioning of
the display rod is correctly repo-
sitioned and reset the clamp (1).
12. Carry out a cable adjustment

4.2.2 Steering cables adjustment

IMPORTANT This adjustment must be executed acting gradually and alternately between the
two registers.
1. With the machine aligned and the steering wheel straight, regulate the adjusters (1) and (2)
at the cable ends to eliminate
any play, so that they are properly
stretched.
2. Apply a dynamometer (3) to the
two cable branches 10 cm from
the front pulley. Applying a force
of 5-7 kg we must obtain a dis-
tance of approximately 45 mm
between the cables.
3. Carry out a test drive with the ma-
chine and check that the steering
wheel remains in the correct position by run-
ning along a straight line.
4. If you need to rotate the steering wheel to ob-
tain a straight line, slightly loosen one adjuster
first (1) or (2) and tighten the other adjuster
(2) or (1) by the same amount, repeating the
procedure several times until optimum condi-
tion is achieved.
5. Lock the adjusters and check the cables ten-
sion again.
CHAPTER
4 - STEERING
4
[ 4.2.2].
1
EDITION
2018
5
2
45 mm
10 cm
PAGE
29 /
84
3