Removal Of The Blades Motor; Footplate Removal - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220

3.1.3 Removal of the blades motor

1. Remove the rear
2. Loosen the four upper screws(1).
NOTE Access to the two front screws is facili-
tated by steering to the right and to the left.
3. Loosen the screw (2) on the right side and
remove the housing (3) consisting of two half
shells.
When mounting, complete in reverse the steps
described above, making sure not to exceed the
tightening of the screw (2) to avoid striping the
thread into the plastic of the of the left half shell
Should this be the case,
4
5

3.1.4 Footplate Removal

1. Fold the seat forward (1) and engage the safe-
ty catch (2).
WARNING!
the seat from accidentally falling out while
working, which could result in hand inju-
ries.
2. Remove the seat (1) secured by four screws
(3).
3 - CHASSIS AND COVERS
cover[ 3.1.1].
6
– Rectify the threaded hole (4) of the left half shell (5) with a 6 mm
drill bit.
– Replace the selfthreading screw (2) with a M5 x 25 cylindrical
head metric screw by adding an M5 nut (6) to be inserted in the
hexagonal seat located at the other end of the hole of the left
half shell.
The safety catch prevents
CHAPTER
3
1
3
2
1
EDITION PAGE
2018 21 /
84
1
1
3
2