Replacing The Belts - Stiga e-PARK 220 Workshop Manual

WORKSHOP MANUAL
e-PARK 220

7.1.3 Replacing the belts

• Removing the blade drive belt
1. Working from the bottom of the machine, pull
the lever (1) of the gallow pulley outwards (2)
to loosen the belt (3) and remove it from the
lower pulley (4)
2. Remove the belt housing (4) unscrewing the
screws (5) with a 12 mm socket wrench.
3. Remove the belt guide (6) and remove the belt
(3) from the pulley (7).
5 5
• Removing the belt for the blade connection
4. Unscrew the screw (8) and remove the pulley (7) from the shaft.
5. Loosen the four screws (9) of the left-hand bearing bracket by a couple of turns, unscrew the
screw (10) and remove the left-hand pulley (11) together with the belt (12).
• Functional checks and assembly
6. Before reassembling the belts, carry out the
following checks on the functionality of the cut-
ting deck;
– Check the condition of the two blade shaft
bearings by grasping and forcing radially
each pulley and blade-holding bar, making
sure that there is no radial play.
– Rotate each shaft. No abnormal bearing
noise should be heard.
CHAPTER
7 - MOWING DECK
4
12
3
1
8
7
6
11 10
EDITION PAGE
2018 43 /
84
2 4
3
9