Nortel Meridian Meridian 1 Upgrade Manual page 147

Install software and customer database on Core 0
Communication Server 1000M and Meridian 1
Procedure 47
Installing the software and customer database
1 Check that a terminal is connected to J25 on Core/Net 0.
2 In Core/Net 0, install the CD-ROM into the CD-ROM drive in the MMDU:
a. Press the button on the CD-ROM drive to open the CD-ROM disk
holder.
b. Place the CD-ROM disk into the holder with the disk label showing.
c. Press the button again to close the CD-ROM disk holder.
Do not push the holder in by hand.
Note: If the CD-ROM is not in the CD-ROM drive, the installation will not
continue. Insert the CD-ROM to continue.
3 Place the CP PII Install floppy disk into the Core/Net 0 MMDU floppy
drive.
Note: If a problem is detected during the system verification, Install
stops, prints an error message, and aborts the installation. If the
verification is not successful, do not continue; contact your technical
support organization.
4 Press the manual RESET button on the CP PII card faceplate in
Core/Net 0.
Before the install runs, the system validates hard disk partitioning which
takes about five minutes.
Testing partition 0
0 percent done...1 percent done......99
percent done....100 percent done
Testing partition 1
0 percent done...1 percent done......99
percent done....100 percent done
Testing partition 2
0 percent done...1 percent done......99
percent done....100 percent completed!
Performing the upgrade
81C IGS to CS 1000M MG CP PII FNF Upgrade
Page 147 of 284