Wolf Sub-Zero ICB400 Series Service Manual page 9

Installation Information
Unit Leveling (ICB427 & ICB427R)
NOTE: Unit must be installed before final leveling. If
unit is anchored to cabinets, remove anchor screws
before leveling, reinstalled after
1. Remove kickplate/grille
2. To raise front, turn front leveler legs counterclock-
wise, clockwise to lower
3. At front of unit base is an adjusting screw that reach-
es to rear leveler assembly. To raise rear, use
Phillips-head screwdriver to turn adjusting screw
clockwise, counterclockwise to lower
(See Figure 2-8).
Rear leveling legs will move only 2 mm (1/16") for
every 18 revolutions of the Phillips-head adjusting
screw. Do not over torque. Use lowest torque set-
ting on any power screwdriver. Do not turn rear
leveling legs by hand, doing so will damage rear
leveler assembly.
7011544 - Revision A - November, 2008
International W
International W
(See Figure 2-5).
(See Figure 2-6).
(See Figure 2-7).
ine Storage
ine Storage
(ICB400)
(ICB400)
Screw
Figure 2-5. Molding & Brackets
Figure 2-6. Kickplate/Grille Removal
Figure 2-7. Adjusting Front Leveling Legs
Rear Leveler
Adjusting Screw
Figure 2-8. Adjusting Rear Levelers
2-4
Series
Series
Side Molding
Unit to Cabinet Bracket
Kickplate/ Grille
Front Leveling Leg
Rear Leveler Assy.