Wolf Sub-Zero ICB400 Series Service Manual page 19

International wine storage
Table of Contents

Advertisement

Electronic Control System
Adjusting Set-Points (Temperature Adjustments)
To adjust set-points, press WARMER or COLDER key on control panel in multiple key strokes until desired set-point
is achieved
(See Figure 3-6).
NOTE:
To check set point, press either the WARMER or COLDER key, keeping in mind that the initial key stroke
will change the previous set-point by a one degree increment or decrement depending on key stroke choice.
NOTE:
The set-point will be displayed on the LCD for ten (10) seconds after the last key stroke. After the 10 second
delay, the compartment temperature will be displayed. As the compartment temperature changes, the temperature
displayed on the LCD will change by no more than one degree per minute.
NOTE:
The temperature range in a wine storage compartment is 3°C (38°F) to 18°C (65°F).
Figure 3-6. Adjust Set-Point, Press
Lighting System ON/OFF
For the purpose of displaying a wine supply, it is possible to energize the lights 100% of the time, even if the door is
closed. To do so, press and release the LIGHTS key
the LIGHTS key again.
Temperature Alarm ON/OFF (Temperature Alarm)
There is an audio/visual temperature alarm that can be enabled to warn a customer if excessive warm or cold tem-
peratures are experienced. To enable the alarm, press and release the key with the bell on it
the alarm is enabled, the BELL ON indicator will illuminate. To disable this feature, press and release the key with
the bell on it again, and the BELL ON indicator will de-energize.
NOTE:
If the alarm is enabled and there is a temperature problem, the BELL ON indicator will flash and the alarm
will beep. The alarm feature can also be tied in with a home security alarm system.
7011544 - Revision A - November, 2008
International W
International W
One key stroke equals one degree (1°) change.
Adjusting lower compartment set-point "colder"
Figure 3-7. Light System ON/OFF, Press
Figure 3-8. Temperature Alarm ON/OFF, Press
ine Storage
ine Storage
(ICB400)
(ICB400)
(COLDER) or
(See Figures 3-7).
To disable this feature, press and release
(LIGHTS) Key
3-6
Series
Series
(WARMER) Keys
(See Figure 3-8).
(ALARM) Key
If

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents