Wolf Sub-Zero ICB400 Series Service Manual page 83

Component Access / Removal
Wine Storage Control Panel Assembly Removal
(Models ICB427 & ICB427R)
The control panel assembly is secured at the front of
the wine compartment divider with six screws at the
bottom and a silicone seal under the top flange. A con-
cealed tab at top center of the control panel housing
helps to position the control panel assembly.
To remove the control panel assembly, first access the
control board and disconnect the lower light strip electri-
cal leads, LED ribbon cable and membrane switch rib-
bon cable, then (See Figure 6-47):
1. Extract the six screws at bottom of control panel.
2. Slide the blade of a putty knife under and along the
top flange of the control panel housing to break sili-
cone seal.
NOTE: Do not lift top flange too vigorously. Doing
so will break the concealed tab at top center.
3. After breaking silicone seal, pull control panel
assembly forward and disconnect ground wire.
NOTE: When reinstalling control panel assembly, a
bead of silicone must be reapplied along inside of the
top flange.
Lower Light Strip Access and Removal
The lower light strip is captivated in the channel of the
light strip housing, which is attached to the control
panel assembly.
To remove the lower light strip, first remove the control
panel assembly, then (See Figure 6-48):
1. Slide light housing off of control panel assembly.
2. Slide light strip out of channel.
7011544 - Revision A - November, 2008
International W ine Storage
International W ine Storage
Do not break
concealed
tab
Figure 6-47. Wine Storage Control Panel Assembly
Light Strip Housing
6-20
Series
Series
(ICB400)
(ICB400)
Screws (6)
Control Panel Assembly
Control Panel Assy
1
Light Strip
2
Figure 6-48. Lower Light Strip
Putty Knife