Wolf Sub-Zero ICB400 Series Service Manual page 54

International W ine Storage Series
International W ine Storage Series
Electronic Control System
(ICB400)
(ICB400)
Manual Entry Model Configuration Mode
Manual Entry Model Configuration Mode allows a Service Technician to verify a main control board of the ICB427R
refrigerator section was configured correctly, and/or to reconfigure the main control board if a mistake was made
during the configuration process.
To initiate Manual Entry Model Configuration Mode the unit must be ON and the bottom drawer open. Then, Press
and hold the drawer ajar ALARM key and the POWER key together for 15 seconds. The unit will now be in Model
Configuration Mode, with the model code of the last configuration displayed (See Figure 3-89 and Model Code Table
on previous page). If needed, toggle through the model codes by pressing WARMER or COLDER keys, until appro-
priate model code is displayed (See Figure 3-90 and 3-91). With appropriate model code displayed, press POWER
key to store model configuration (See Figure 3-92).
Figure 3-89. Press Alarm and POWER key to Initiate Manual Entry Model Configuration Mode
Figure 3-90. Press WARMER or COLDER key to Toggle Through Model Codes
Figure 3-91. Stop When Appropriate Model Code is Displayed
Figure 3-92. Press POWER Key to Store Model Configuration
3-41
7011544 - Revision A - November, 2008