Wolf Sub-Zero ICB400 Series Service Manual page 80

International W
International W
MODELS ICB427 AND ICB427R INTERIOR COSMETIC AND MECHANICAL COMPONENTS
Wine Rack Assembly Removal
To remove a wine rack assembly
1. Pull rack forward until it stops.
2. Lift front of rack up while pulling forward.
3. After indentations on the wine rack clear the rollers
on the cabinet slides, lower front of rack while con-
tinuing to pull forward and lifting rear of rack.
Cabinet Slide, Spacer / Support Spacer Removal
Cabinet slides, slide spacers and/or support spacers
are attached to side walls with screws.
To remove a cabinet slide, slide spacer or support spac-
er, extract the Phillips head mounting screws and pull
the slide and slide spacer, and/or support spacer from
the wall (See Figure 6-39).
Upper Light Strip Removal
The light strip is captivated in the channel of the light
strip housing.
To remove the upper light strip, remove the upper wine
rack assemblies first, then
1. Extract the screws securing housing to the ceiling,
and lower housing down.
2. Disconnect light strip electrical leads.
3. Extract screw securing ground wire to the housing.
4. Slide light strip out end of channel.
NOTE: When reinstalling the light strip housing, all wire
leads must be tucked back behind the light strip hous-
ing before resecuring it to the ceiling.
ine Storage
ine Storage
(See Figure 6-38):
(See Figure 6-40):
Series
Series
Component Access / Removal
(ICB400)
(ICB400)
Lift front while pulling forward;
After indentations clear rollers,
lower front, pull forward, lift rear.
Figure 6-38. Wine Rack Assembly Removal
Slides
Figure 6-39. Slide, Spacer &/or Support Spacer
Channel
Light Strip Housing
Figure 6-40. Upper Light Strip Removal
6-17
Screws
Support Spacer
Light Strip
7011544 - Revision A - November, 2008
Spacer