Wolf Sub-Zero ICB400 Series Service Manual page 79

Component Access / Removal
Door Assembly Removal (Models ICB427 &
ICB427R)
The door assembly is held in place with Allen-head
screws that pass down through the arm of the top hinge
assembly and up through the arm of the bottom hinge
assembly, then into the door. These mounting screws
are concealed by a hinge cover on each hinge arm.
The hinge covers are held in place by tabs that fit into
notches in the hinge arms.
NOTE: Removing the top drawer from a model
ICB427R first will make this task easier.
To remove a door assembly
1. Open door and removing both hinge covers.
2. With Allen-head wrench, extract the two inner-most
door mounting screws from top and bottom hinge
arms, leaving the two outer-most screws in place.
3. Close door and extract the outer-most door mount-
ing screws from bottom hinge arm.
4. Extract the two outer-most door mounting screws
from top hinge arm.
5. Lift door from unit.
Hinge Assembly Removal
(Models ICB427 & ICB427R)
The hinge assemblies are attached to hinge mounting
brackets with Allen-head bolts.
To remove a hinge assembly, remove the door assem-
bly first. Then, extract the Allen-head bolts from the
appropriate hinge mounting bracket and pull the hinge
assembly from the unit.
7011544 - Revision A - November, 2008
International W
International W
(See Figure 6-36):
(See Figure 6-37)
ine Storage
ine Storage
(ICB400)
(ICB400)
2
Remove two outer-most
screws at bottom hinge
first then at top, with door
closed.
Hinge Cover
Figure 6-36. Door Assembly Removal
Bolt
Hinge Arm
Figure 6-37. Hinge Assembly Removal
6-16
Series
Series
Remove two inner-most
1
screws at top and bottom
hinge with door open.
o r
D o
b l y
s e m
A s
Hinge Arm
Bolt