Wolf Sub-Zero ICB400 Series Service Manual page 68

International W
International W
MODEL ICB424 INTERIOR COSMETIC AND MECHANICAL COMPONENTS
Wine Rack Assembly Removal
To remove a wine rack assembly
1. Pull rack forward until it stops.
2. Lift front of rack up while pulling forward.
3. After indentations on the wine rack clear the rollers
on the cabinet slides, lower front of rack while con-
tinuing to pull forward and lifting rear of rack.
Cabinet Slide, Spacer and Support Spacer Removal
Cabinet slides are attached to side walls with screws. If
on the handle side of the compartment, a small plastic
spacer is between the front of the slide and the side
wall. If on the hinge side, a wide plastic support spacer
is between the slide and the wall.
To remove a cabinet slide, extract the Phillips head
mounting screws and pull the slide and slide spacer,
and/or support spacer from the wall
Upper Light Strip Removal
The light strip is captivated in the channel of the light
strip housing.
To remove the upper light strip, remove the upper wine
rack assemblies first, then
1. Extract the screws securing housing to the ceiling,
and lower housing down.
2. Disconnect light strip electrical leads.
3. Extract screw securing ground wire to the housing.
4. Slide light strip out end of channel.
NOTE: When reinstalling the light strip housing, all wire
leads must be tucked back behind the light strip hous-
ing before resecuring it to the ceiling.
ine Storage
ine Storage
(See Figure 6-7):
(See Figure 6-8).
(See Figure 6-9):
Series
Series
Component Access / Removal
(ICB400)
(ICB400)
Lift front while pulling forward;
After indentations clear rollers,
lower front, pull forward, lift rear.
Figure 6-7. Wine Rack Assembly Removal
Slides
Figure 6-8. Slide, Spacer & Support Spacer
Channel
Light Strip Housing
Figure 6-9. Upper Light Strip Removal
6-5
Screws
Support Spacer
Light Strip
7011544 - Revision A - November, 2008
Spacer