Wolf Sub-Zero ICB400 Series Service Manual page 85

Component Access / Removal
Refrigerator Wire Tray Removal
(Model ICB427R Only)
The wire tray is rests on pegs at the left and at the back
right corner of the duct cover. It is set between the two
drawer areas.
To remove a wire tray (See Figure 7-52):
1. Remove display wire harness from wire clip.
2. Lift right side of wire tray up, then pull it to the right
and out of the compartment.
NOTE: There may be a screw under the tray at the
back right corner that needs to be loosened prior to
step 2 above.
Refrigerator Drawer Closer Assembly Removal
(Model ICB427R Only)
Drawer closer assemblies are located on the right side
wall. Two screws secure each assembly to the wall.
To remove a drawer closer assembly, extract screws
that secure drawer closer to wall and pull drawer closer
assembly from wall. (See Figure 7-53)
Refrigerator Drawer Slide Assembly Removal
(Model ICB427R Only)
There are four drawer slide assemblies, two on each
side wall. Drawer slide assemblies are attached to side
walls with Allen-head screws passing through the draw-
er slide bracket into blind threaded inserts.
To remove a drawer slide assembly, extract mounting
screws with a 5/32" Allen-head wrench, and pull drawer
slide assembly from wall.
NOTE: The white thread pins at end of drawer slides
are replaceable. Screw pins counterclockwise to
remove them. (See Figure 6-54)
7011544 - Revision A - November, 2008
International W
International W
(See Figure 6-54)
ine Storage
ine Storage
(ICB400)
(ICB400)
Figure 7-52. Wire Tray Removal
Drawer Closer Assy
Figure 7-53. Drawer Closer Assembly Removal
Figure 6-54. Drawer Slide Assembly & Pin
6-22
Series
Series
Wire Tray
White Thread Pin