Overlay Control Category; Overlay Feature Descriptions; Figure 51: Camexpert Overlay Category; Table 22: Overlay Feature Descriptions - Teledyne FLIR A68 Series User Manual

Overlay Control Category

The Overlay Control category, as shown by CamExpert, groups parameters used to
enable and configure a graphic overlay in the output image. Each overlay can be
individually set active allowing multiple overlays at the same time.
For more information on using overlays, refer to the

Overlay Feature Descriptions

The following table describes these parameters along with their view attribute.

Table 22: Overlay Feature Descriptions

Display Name
Overlay Global Mode
Off
Active
Overlay Selector
Reticle
Colormap
Frame Counter
Alarm Status
Metadata
FLIR A68/A38 Series IR Camera User's Manual

Figure 51: CamExpert Overlay Category

Feature & Values
overlayGlobalMode
Off
Active
overlaySelector
GraphReticle
GraphColorMap
TextFrameCount
AlarmStatus
MetaOverlay
Overlays
Description
Sets the enable state of the display of overlays.
This globally enables/disables the display of all
currently enabled overlays in the image.
Disable overlay display.
Enable display of overlays.
Selects the graphic overlay for which to modify
settings.
Reticle (crosshair) graphic overlay. By default, the
reticle position is in the center of the image (320,
240).
Displays the range of possible pixel colors in the
image as a rectangular graphic (10 pixels high),
increasing intensity from left to right. By default,
the color map position in the bottom right (370,
470).
Frame counter graphic overlay. By default, the
frame counter position is in the bottom left corner
(0, 465).
Pixels in image will contain the status of the alarms
The metadata associated to the frame will be drawn
into the image. Can be useful when using a 3
party GigE Vision implementation that doesn't
support metadata. By default, the metadata overlay
position is the top-left corner (0,0).
section.
rd
Operational Reference • 115
View
Beginner
DFNC
Beginner
DFNC