Table of Contents
Advertisement
3-14.11 QoS Control List Configuration
The section shows the QoS Control List (QCL), which is made up of the QCEs. Each row
describes a QCE that is defined. The maximum number of QCEs is 256 on each switch. Click
on the lowest plus sign to add a new QCE to the list.
Web Interface
To configure the QoS Control List parameters in the web interface:
1. Click Configuration, QoS, QoS Contol List
2. Click the
3. Scroll all parameters and evoke the Port Member to join the QCE rules
4. Click the Apply to save the setting
5. If you want to cancel the setting then you need to click the Reset button.
It will revert to previously saved values
Figure 3-14.11: The QoS Control List Configuration
Parameter description:
QCE# :
Indicates the index of QCE.
Port :
Indicates the list of ports configured with the QCE.
Frame Type :
Indicates the type of frame to look for incoming frames. Possible frame types are:
Any: The QCE will match all frame type.
Ethernet: Only Ethernet frames (with Ether Type 0x600-0xFFFF) are allowed.
LLC: Only (LLC) frames are allowed.
SNAP: Only (SNAP) frames are allowed
IPv4: The QCE will match only IPV4 frames.
IPv6: The QCE will match only IPV6 frames.
to add a new QoS Control List
XGS3600 Series User's Guide
204
Advertisement
Table of Contents
