ZyXEL Communications XGS3600 Series Manual page 70

TCP ACK

Specify the TCP "Acknowledgment field significant" (ACK) value for this ACE.
0: TCP frames where the ACK field is set must not be able to match this entry.
1: TCP frames where the ACK field is set must be able to match this entry.
Any: Any value is allowed ("don't-care").
TCP URG

Specify the TCP "Urgent Pointer field significant" (URG) value for this ACE.
0: TCP frames where the URG field is set must not be able to match this entry.
1: TCP frames where the URG field is set must be able to match this entry.
Any: Any value is allowed ("don't-care").
TCP/UDP Parameters
The Ethernet Type parameters can be configured when Frame Type "Ethernet Type" is
selected.
EtherType Filter

Specify the Ethernet type filter for this ACE.
Any: No EtherType filter is specified (EtherType filter status is "don't-care").
Specific: If you want to filter a specific EtherType filter with this ACE, you can
enter a specific EtherType value. A field for entering a EtherType value appears.
Ethernet Type Value

When "Specific" is selected for the EtherType filter, you can enter a specific
EtherType value. The allowed range is 0x600 to 0xFFFF but excluding
0x800(IPv4), 0x806(ARP) and 0x86DD(IPv6). A frame that hits this ACE
matches this EtherType value.
Buttons

Apply – Click to apply changes.
Reset- Click to undo any changes made locally and revert to previously saved
values.
Auto-refresh:

To evoke the auto-refresh to refresh the information automatically.
Upper right icon (Refresh, clear, Remove All)

You can click them for refresh the ACL configuration or clear them by manual.
Others remove all to clean up all ACL configurations on the table.
XGS3600 Series User's Guide
63